Modelling infill wall

[warcorsario]

Dears

Is possible modelling infill wall in Building modeler?, because is very complicated draw infill wall in seismostruct in models contain large elements, or maybe exist other method most easy to draw infill wall?

[z.gronti]

Dear warcorsario,

The infill member is not available in the Building Modeller of the current version.
According to SeismoStruct's User Manual: "Four nodes need to be defined for this element type. These correspond to the corners of the infill panel, must be entered in anti-clockwise sequence starting from the lower-left-hand corner and must all belong to the same plane."

[Mahesh Raj Bhatt]

Could you plz define each parameters of infills like strains, stresses, strut area, curve parameters etc??

[z.gronti]

Dear Mahesh Raj Bhatt,

You may find in Chapter 4 of Verification report examples five models with infills.
Further, you may find more models with infills in SeismoStruct sample models, available in the following link:
https://seismosoft.com/seismobuild-seis ... le-models/