I had a very complex model that I have simplified and I'm going to check out the simple structure.
I want to manual change the section properties valves, Ix, Iy etc to account for the extra stiffness of the complex model. Does anyone know where I can get to the section proerties and not just the dimensions of them?
Rich
Section Properties
Re: Section Properties
On the Sections tab, under Add, you'll find three sub-tabs:
1. Materials and Dimensions
2. Reinforcement
3. Mass and Geometrical Characteristics
EA, EI2, EI3, and GJ are all available on sub-tab 3. You cannot change them here. Your best bet might be to create an artificial material with E and G high enough to mimic the increase in stiffness you desire.
Good luck rich.
1. Materials and Dimensions
2. Reinforcement
3. Mass and Geometrical Characteristics
EA, EI2, EI3, and GJ are all available on sub-tab 3. You cannot change them here. Your best bet might be to create an artificial material with E and G high enough to mimic the increase in stiffness you desire.
Good luck rich.
Tim Huff