Issue with Post-Processor and SeismoPatch in SeismoStruct v2025

[a1shaer]

I am currently using SeismoStruct v2025 (Release-2, Build-1) and have encountered two issues:

1. Post-Processor Error
I developed a model in SeismoBuild, converted it to SeismoStruct, and ran the analysis. However, when I attempt to open the post-processor to view the results, I receive the following error message:

"SeismoStruct found differences between the input .SPF and output .SRF, and the results cannot be displayed. Please go to the processor and run the analysis again."

I have tried rerunning the analysis multiple times, but the issue persists. Notably, I have previously developed models using SeismoStruct v2024 and run them in v2025 without encountering this problem.

2. SeismoPatch Execution Issue
Whenever I run a model developed using SeismoStruct v2024 in SeismoPatch v2025, I get the following error:

"Failed to execute or Binary SRF file not Output."

I would appreciate any guidance on resolving these issues. Has anyone else faced similar problems after upgrading to v2025?

Thank you for your support.

[z.gronti]

Dear a1shaer,

Could you please send us the models that create the reported errors at z.gronti@seismosoft.com to check them?