Hi,
While Modelling infill wall as a strut using truss element, It is showing the following Error:
"Wrong confinement factor value encountered in procedure SectStfCon_ma"
I don't know how to attach the picture in the forum.
Anyway, When I model strut in older versions as a concrete material, it used to run properly. But in Version 7. 0.3 it is showing this error even If i am making a brand new file.
Thanks for the help
Error in Processor when modelling strut
Re: Error in Processor when modelling strut
Dear Gemini,
You have possibly assigned a concrete model in a steel section. You may either use an elastic material model or use the rcrs section without reinforcement.
You have possibly assigned a concrete model in a steel section. You may either use an elastic material model or use the rcrs section without reinforcement.
Zoi Gronti
Seismosoft Srl.
Seismosoft Srl.
Re: Error in Processor when modelling strut
Thank you.. RCRS section without reinforcement has worked 
