Dear value:
I am Majd Attar from Amman-Jordan
my question is after modeling push over analysis
how to install response spectrum on the same graph????
Best Regardes
pushover + response spectrum
Re: pushover + response spectrum
Hi majid
seismostruct doesn't work on response spectrum of building base on any codes.this just can be found on Etabs or sap2000
seismostruct doesn't work on response spectrum of building base on any codes.this just can be found on Etabs or sap2000
-
seismosoft
- Posts: 1316
- Joined: 06 Jul 2007, 04:55
Re: pushover + response spectrum
Dear Majd Attar,
As correctly noted by salar, SeismoStruct does not currently carry out the type of overall capacity-demand comparisons that you mention.
You may, however, obviously do such comparisons outside of the program, superimposing a pushover curved obtained with SeismoStruct (after it has been adequately transformed into its SDOF equivalent) with the response spectrum for your site.
Seismosoft Support
As correctly noted by salar, SeismoStruct does not currently carry out the type of overall capacity-demand comparisons that you mention.
You may, however, obviously do such comparisons outside of the program, superimposing a pushover curved obtained with SeismoStruct (after it has been adequately transformed into its SDOF equivalent) with the response spectrum for your site.
Seismosoft Support