Hello,
We checked again the report and it seems to be correct. Maybe we are missing something. Can you please be a bit more specific, specifying which are the exact values that do not seem to be correct? You could also send your project with more details at support@seismosoft.com
Note that in pushover analysis the spectrum is employed in the calculation of the target displacement only. You could also check these calculations too.
Cheers
Seismosoft Support
ASCE 41-23 Spectra
-
struct.ichi
- Posts: 6
- Joined: 25 Feb 2026, 03:11
Re: ASCE 41-23 Spectra
Thank you for your response. I sent an email to the address you have provided. Thanks!
-
seismosoft
- Posts: 1315
- Joined: 06 Jul 2007, 04:55
Re: ASCE 41-23 Spectra
Thank you for the feedback.
We already replied to your email. The reports comes out correctly in our system; possibly you will need to update SeismoBuild to the latest v2026 release.
Seismosoft Support
We already replied to your email. The reports comes out correctly in our system; possibly you will need to update SeismoBuild to the latest v2026 release.
Seismosoft Support
-
seismosoft
- Posts: 1315
- Joined: 06 Jul 2007, 04:55
Re: ASCE 41-23 Spectra
Hello,
We have addressed the issue that you reported in your initial post and from SeismoBuild v2026, Release-2, build-25 onwards it is possible to specify the spectrum parameters for all the seismic hazard levels in ASCE 41. Thank you for your feedback!
Seismosoft Support
We have addressed the issue that you reported in your initial post and from SeismoBuild v2026, Release-2, build-25 onwards it is possible to specify the spectrum parameters for all the seismic hazard levels in ASCE 41. Thank you for your feedback!
Seismosoft Support