Step Output

[TreVayne]

Hi,
I have a trouble with that:
In my analysis I use a seismic signal with dt 0.005s, but in a post-processor output step the dt is changing automatically to 0.05s, but in analysis is a 0,005s. How to decrease the output step from 0.05s to 0.005s when the time step in load curves and time history Stages is a 0.005 ?

I use a academic version of SeismoStruct

Thank You!

Mark

[huffte]

Is it possible that you may have inadvertently changed the "Frequency of Output" from 1 to 10 in the "Analysis Output" tab of the SeismoStruct pre-processor?

[TreVayne]

Thank you a lot, the Frequency of Output is that what i looking for !

Mark