Issue with Post-Processor and SeismoPatch in SeismoStruct v2025
Posted: 04 Apr 2025, 13:21
I am currently using SeismoStruct v2025 (Release-2, Build-1) and have encountered two issues:
1. Post-Processor Error
I developed a model in SeismoBuild, converted it to SeismoStruct, and ran the analysis. However, when I attempt to open the post-processor to view the results, I receive the following error message:
"SeismoStruct found differences between the input .SPF and output .SRF, and the results cannot be displayed. Please go to the processor and run the analysis again."
I have tried rerunning the analysis multiple times, but the issue persists. Notably, I have previously developed models using SeismoStruct v2024 and run them in v2025 without encountering this problem.
2. SeismoPatch Execution Issue
Whenever I run a model developed using SeismoStruct v2024 in SeismoPatch v2025, I get the following error:
"Failed to execute or Binary SRF file not Output."
I would appreciate any guidance on resolving these issues. Has anyone else faced similar problems after upgrading to v2025?
Thank you for your support.
1. Post-Processor Error
I developed a model in SeismoBuild, converted it to SeismoStruct, and ran the analysis. However, when I attempt to open the post-processor to view the results, I receive the following error message:
"SeismoStruct found differences between the input .SPF and output .SRF, and the results cannot be displayed. Please go to the processor and run the analysis again."
I have tried rerunning the analysis multiple times, but the issue persists. Notably, I have previously developed models using SeismoStruct v2024 and run them in v2025 without encountering this problem.
2. SeismoPatch Execution Issue
Whenever I run a model developed using SeismoStruct v2024 in SeismoPatch v2025, I get the following error:
"Failed to execute or Binary SRF file not Output."
I would appreciate any guidance on resolving these issues. Has anyone else faced similar problems after upgrading to v2025?
Thank you for your support.