Hello SeismoMatch developer
Can I change time step from 0.01 to 0.02?
My time histories have time stepping 0.02 and I want to remain this time stepping for the matched time histories. Can I do that?
Thanks
Changing time step
Re: Changing time step
Dear sadraddin,
You may change the time-step of the time-history in the "Input File Parameters" module, when loading the accelerogram.
You may change the time-step of the time-history in the "Input File Parameters" module, when loading the accelerogram.
Zoi Gronti
Seismosoft Srl.
Seismosoft Srl.
Re: Changing time step
Thanks for your response. I mean I want to remain as dt=0.02 sec but seismomatch gives dt=0.01 sec. So, can I do that? or is there any software doing this?
Thanks z.gronti
Thanks z.gronti
Re: Changing time step
Dear Sadraddin,
Open the accelerogram through File > Open Single..., in the "Input File Parameters" module you should set the "Time Step dt" parameter equal to 0.02. If you do so, then the matched accelerogram will be created with a time step equal to 0.02.
Open the accelerogram through File > Open Single..., in the "Input File Parameters" module you should set the "Time Step dt" parameter equal to 0.02. If you do so, then the matched accelerogram will be created with a time step equal to 0.02.
Zoi Gronti
Seismosoft Srl.
Seismosoft Srl.