Page 1 of 1
pushover + response spectrum
Posted: 25 Aug 2013, 16:29
by Majd Attar
Dear value:
I am Majd Attar from Amman-Jordan
my question is after modeling push over analysis
how to install response spectrum on the same graph????
Best Regardes
Re: pushover + response spectrum
Posted: 25 Aug 2013, 20:26
by salar
Hi majid
seismostruct doesn't work on response spectrum of building base on any codes.this just can be found on Etabs or sap2000
Re: pushover + response spectrum
Posted: 26 Aug 2013, 04:59
by seismosoft
Dear Majd Attar,
As correctly noted by salar, SeismoStruct does not currently carry out the type of overall capacity-demand comparisons that you mention.
You may, however, obviously do such comparisons outside of the program, superimposing a pushover curved obtained with SeismoStruct (after it has been adequately transformed into its SDOF equivalent) with the response spectrum for your site.
Seismosoft Support