Seismosoft | Earthquake Engineering Solutions

Dear Seismosignal Users,

Does the latest version of the software have the ability to add a pulse or pulses to a record?
If the answer is yes, could you provide step-by-step instructions for it?

Thanks in advance,
Sahar

SeismoSignal has the capability to detect pulses in a record. To my knowledge, there is no capability for adding a pulse. You can add wavelets to spectrally match a record to a target response spectrum using SeismoMatch. As a side note, you will be more likely to get multiple responses if you place your posts in the correct forum (this was placed in SeismoBuild, but should have been posted in SeismoSignal).