Seismosoft | Earthquake Engineering Solutions

Hi seismosoft group,

I am trying to extract only the axial forces of a specific load combination (e.g. G+0.3Q, it's according to Eurocode) for the vertical elements (walls and columns), how can I check them? Is there any way to extract them as an Excel table? Do I have to check every element separately?
Thank you in advance.

Dear Christine23,

You may run the pushover analysis, go to the post-processor, i.e. Show results area, and check the values you are interested in for Output No.1 Load Factor: 0.00, where only the static loads are applied.

Where could I find post processor in seismobuild?
I run the pushover analysis and on the left there is a column with: building modelling, code requirements, eigenvalue analysis, pushover analysis, checks and report. Do i have to create a report? Or do I check the results in pushover analysis tab?

Dear Christine23,

After running the pushover analysis, you should select the "Show Results" button, in order for you to be able to check the results of the pushover analysis.