Page 1 of 1
GetframeStiffness error in SMA reinforced frame model.
Posted: 10 Mar 2022, 08:00
by shahadfaiz
When Incremental Dynamic Analysis is done on SMA reinforced frame, an error is shown. The error message is, "Material model not identified in procedure GetframeStiffness. Material model type: 16". How to resolve this issue?
Re: GetframeStiffness error in SMA reinforced frame model.
Posted: 11 Mar 2022, 15:03
by z.gronti
Dear shahadfaiz,
Could you please send me your model at
z.gronti@seismosoft.com to check it?
Re: GetframeStiffness error in SMA reinforced frame model.
Posted: 12 Mar 2022, 08:47
by sankalpsss
same error I have been recieved
Re: GetframeStiffness error in SMA reinforced frame model.
Posted: 14 Mar 2022, 14:40
by z.gronti
Dear sankalpsss,
Could you please send me your model at
z.gronti@seismosoft.com to check it?
Re: GetframeStiffness error in SMA reinforced frame model.
Posted: 14 Mar 2022, 18:58
by seismosoft
We have spotted a bug in v2022 Release-2 in the calculation of the tangent structural stiffness, when se_sma is employed. The bug will be fixed in v2022 Release-3, which will be published in 1-2 weeks.
Seismosoft Support