Page 1 of 1
stress and strain data
Posted: 08 Nov 2021, 13:59
by Akash bhagat
Dear concern,
I am a new user of seismostruct and is unable to get the stress data for my model. In the analysis output the element name and stress points are not getting selected. Any suggestions regarding it would be very helpful.
Thanking you,
Yours sincerely,
Akash Bhagat
Tezpur University
Re: stress and strain data
Posted: 09 Nov 2021, 08:35
by z.gronti
Dear Akash bhagat,
You should make the proper selection in the Analysis Output tab of the Pre-Processor, i.e. select the elements to export the stress and strain peaks or select to export stresses and strains at selected locations.
Re: stress and strain data
Posted: 17 Nov 2021, 08:41
by Akash bhagat
I'm a new user and facing a problem i,e,. not able to make graph between stress and strain and also a problem at the time of analysis i,e,. Zero diagonal term encountered at the following node: Node 3
with regards,
Akash Bhagat
Tezpur university
Re: stress and strain data
Posted: 17 Nov 2021, 13:31
by z.gronti
Dear Akash bhagat,
Unfortunately, I cannot help you if you do not describe the problem you are facing in detail. Have you selected to export the stresses-strains you want to in the Pre-Processor, as I described in my previous post?
Please carry out a search on this forum for the term "zero diagonal terms"