Seismosoft | Earthquake Engineering Solutions

Hello everyone , my name is Peter Cantona
an undergraduate student from Atma Jaya University , Indonesia and doing my final project for my academics
i got my legal license from my supervisor dongle for seismobuild

My problem is that i already model the existing structure from the data and i did exactly the same , but this message always pop "Unable to apply the entire load" saying that my load isnt adequate or excess

i did recalculate everything and the same thing always happen , so i cant go to pushover analysis
is anyone out here want to comment or help me for my work? i would like to send my file and accept any comment or solution
thank you

There are numerous posts in this forum regarding convegence difficulties. As a start you might want to run an eigenvalue analysis to see if the structural members are well connected with each other.
Seismosoft Support