Seismosoft | Earthquake Engineering Solutions

Hello!

I want to create a new material with my properties. So, by "Add General Material" i created a new material. Also i created my Sample Plot and put it in a new material. After i pressed OK.


But when i open again the properties of my new material, i see that Strain Curve i created have changed.


Why it happened? What can i do?

Thank you!!!

As written in the note, the values are ONLY a sample plot, so that users can see and check the properties of the material model. The values on the table are an indicative time-history for this purpose.
Seismosoft Support