Seismosoft | Earthquake Engineering Solutions

Hello!!!

I want to create diagonal struts in my frame.
I know, that in Seismostruct i can create infill panel with strut and shear curves.

But i need something else. I calculated by KAN.EPE width of strut, failure strain and failure deformations. I need the struts work only for compressive
without deducting buckling length and buckling failure.
After i created the material with properties i need.


Later i created a section of my strut (compression brace).


After in "Element Classes ->truss" i created truss element with material i created.


By "Element Connectivity" i created two struts and began the analysis.


But analysis can't run.


What i did wrong?
Please help me!

Thank you!!!

Probably you need to decrease the load increment.
Seismosoft Support

seismosoft wrote: 16 Jun 2020, 11:21 Probably you need to decrease the load increment.
Seismosoft Support

I did that but have the same result.

sanya greek wrote: 17 Jun 2020, 12:40

seismosoft wrote: 16 Jun 2020, 11:21 Probably you need to decrease the load increment.
Seismosoft Support

I did that but have the same result.

I changed some numbers in materials and now it work.