Seismosoft | Earthquake Engineering Solutions

hi,
I need an accelerogramme mached from a lot of real accelerogramme
How to record it?

Wahida, I'm not certain exactly what you are asking. But the general procedure to modify real accelerograms to match a target spectrum in SeismoMatch is:

1. Load the real accelerograms into SeismoMatch
2. Define the Target Spectrum
3. Set the desired matching parameters such as period range, tolerance, etc.
4. Perform the matching.
5. Save the modified accelerograms, either by directly saving from SeismoMatch (if this works on your system) or by copying and pasting modified accelration data into SeismoSignal and saving from there.

Best of luck and kind regards wahidi.