Seismosoft | Earthquake Engineering Solutions

Hello!

I use Response Spectrum Analysis in the Seismostruct. I found all combinations of forces, moment forces and shear. After i need to compare the forces from RSA(Analysis) with the resistance of beam and columns.
Is it possible to find resistances of all elementsin program? And how?

Thank you!!!

In the linear analysis the checks need to be done in terms of forces and bending moments.
Unfortunately, rhis is not done automatically in SeismoStruct v2020. Hence, hand calculations are needed.
Seismosoft Support

I can not find " linear analysis the checks need to be done in terms of forces and bending moments".
Where can i change it?

Thank you!

seismosoft wrote: 07 May 2020, 12:29 In the linear analysis the checks need to be done in terms of forces and bending moments.
Unfortunately, rhis is not done automatically in SeismoStruct v2020. Hence, hand calculations are needed.
Seismosoft Support

I can not find " linear analysis the checks need to be done in terms of forces and bending moments".
Where can i change it?

Thank you!

As I mentioned above, the checks in RSA (which is a linear analysis) are not done automatically in SeismoStruct.
Seismosoft Support