Seismosoft | Earthquake Engineering Solutions

I seem to be unable to change the loading phase of my static pushover analysis to anything but 1.2mm (i.e. 50 steps for a target displacement of 60mm or 75 steps for a target displacement of 90mm). Any other configuration will refuse to converge or produce bogus results. What am I doing wrong?

Jaime

Dear Jaime,

There are tens of things that could be wrong with your model, as you can readily gather from reading other posts in this Forum (search for "convergence"). We suggest you to read carefully such posts (as well as the Help System).

Seismosoft Support