Seismosoft | Earthquake Engineering Solutions

Hi!

I am running Seismosignal v.4.1.2 on Windows 7. I have some problems to apply baseline correction to accelerograms. I can select the type of correction (constant, linear, etc.), but there are no polynomial coefficients to select below and no correction is applied. Is it a problem with this version of Seismosignal or a compatibility problem?

This problem occurred after a reinstallation of the windows. The last Seismosignal (I do not know what version!) was running (without problems!!!) also on Windows 7.

Thanks.

At least on my installation, I do not see the coefficients until I select "Apply Baseline Correction" and hit "Refresh". Then, I see the coefficients which, as noted in the Help System, are for information only, and cannot be changed by the user.

Note that for the most appropriate and timely response, questions should be addressed in the proper forum.