Seismosoft | Earthquake Engineering Solutions

I am running Seismosignal v.4.1.2 on Windows 7. I have some problems to apply baseline correction to accelerograms. I can select the type of correction (constant, linear, etc.), but there are no polynomial coefficients to select below and no correction is applied. Is it a problem with this version of Seismosignal or a compatibility problem? This problem occurred after a reinstallation of the windows. The last Seismosignal (I do not know what version!) was running (without problems!!!) also on Windows 7. Thank you!

Sorry! After a few restarts of the program I had the ideea to start in compatibility mode with Windows XP SP3 and all returned to normal. I am finally able to apply correction to accelerograms.

Ghindea,

We are happy that you managed to find the solution to the problem you were experiencing, and even more so that you reported it back in this Forum, so that others may benefit from it. Appreciated.

Seismosoft Support