Page 1 of 1
registering multiple installations
Posted: 20 Sep 2017, 13:36
by cc17
Hi there
Is there a method for registering Seismostruct via the command line interface, using an academic license we have been provided?
I have circa 100 PCs install Seismosoft on and obviously, it would be fairly time consuming to register them all individually.
Please advise, thanks.
--
Charlie
Re: registering multiple installations
Posted: 21 Sep 2017, 14:52
by seismosoft
Unfortunately there is no command line interface for the registration.
We could send you a registry license key, instead. Let us know, if this option is good for you.
Regards,
Seismosoft Support
Re: registering multiple installations
Posted: 27 Sep 2017, 16:13
by cc17
Thanks for your reply. I have been supplied a valid academic license, but as I need to apply this to circa 100+ installations, I was hoping that there was a way to feed this information to the MSI installer, such that the product installs *and* registers itself silently. I can install just the product silently now, but it's the post-installation product registration that's the hitch.
Yes, please would you send me a Registry license key and I'll give that a go. Cheers
Re: registering multiple installations
Posted: 28 Sep 2017, 14:58
by z.gronti
Dear cc17,
Could you please send your request at
licensing@seismosoft.com?