Error fbd_tol
Posted: 10 May 2017, 05:38
I can't solve fbd_tol error. I see your video about error messages, but, it doesn't work for my model. I want to run a static pushover analysis for a ssymetric two story RC structure. The load pattern was define. The loading phase is force control, 100 kN with 100 steps. When I decrease the target load factor equal to 50, there is no error, but, for 100, fbd_tol was appear. The output analysis log showed that in the value equal to t4, this error was start. It was continue to 57 and then, the analysis was stop: "unable to apply the entire phase load. Phase terminated."
How can solve this problem?
In your video, there are three solutions. I have done all of them, but the problem was remained.
How can solve this problem?
In your video, there are three solutions. I have done all of them, but the problem was remained.