Seismosoft | Earthquake Engineering Solutions

Good morning,

I am trying to apply baseline correction and filtering to a set of acceleration data. I had an old version of seismosignal which was working fine, but as soon as I dowloaded a new version I realised that I can't apply any baseline correction or filtering anymore. The "Refresh" button is not active. Is there a way I can fix the problem? I tried to uninstall and install again the software but nothing changed.
Thanks

Arianna

Dear ariannagea,

Could you please check if the assigned values in the 'Order & Frequencies' field are valid? If the values are in red font indicates that they are not valid and that is what causes the deactivation of the Refresh button.