Wrong element type

[gemini]

I am modelling infill wall as a strut element. the error is appeared during analysis

"Wrong element type passed to SetZeroStressPnt procedure"

Can you please help me why this error coming?? I have made an RC one storey one bay bare frame (No error), but when I add an equivalent strut as truss element providing it as rcrs section then it shows the above error. If I change the parameter R of stl_mp model then it runs. Please help

Thanks

[z.gronti]

Dear gemini,

Would you like to send me your model to check it?

[gemini]

i have emailed on this id z.gronti@seismosoft.com

[z.gronti]

Dear gemini,

I didn't get the reported message with the SeismoStruct v7.0.6. Could you please tell me which SeismoStruct version you use?