Page 1 of 1
error"floating division by zero"
Posted: 18 Jan 2016, 13:11
by delbazsamad
Hi. when I open seismomatch, an error" floating division by zero" appears.
How can I eliminate ones?
Re: error"floating division by zero"
Posted: 19 Jan 2016, 09:11
by z.gronti
Dear delbazsamad,
If this error message appears whenever you open the program, please try to reinstall the SeismoMatch.
I would also suggest you to download the latest version of SeismoMatch in Seismosoft's download page:
http://www.seismosoft.com/downloads
Re: error"floating division by zero"
Posted: 20 Jan 2016, 13:18
by delbazsamad
Dear Zoi Gronti,
unfortunately, I reinstall the SeismoMatch and download the latest version So, but the error appears again.
many Thanks and best regards.
Re: error"floating division by zero"
Posted: 26 Jan 2016, 18:52
by seismosoft
Hi Delbazsamad,
What is your Operating system that you are using?
Note that our applications are supported in Windows 7, 8 and 10, although they should run fine under Windows XP too.
Further, are you using the program in trial version or you have it registered? If the program is registered can you please send your license key details at
support@seismosoft.com so that we have it checked?
Seismosoft Support
Re: error"floating division by zero"
Posted: 05 Mar 2024, 21:25
by Nima.m
delbazsamad wrote: 20 Jan 2016, 13:18
Dear Zoi Gronti,
unfortunately, I reinstall the SeismoMatch and download the latest version So, but the error appears again.
many Thanks and best regards.
No need to uninstall and reinstall the program.
To solve this problem, you only need changes in the
Region section. please change the settings of your operating system to the default mode!
good luck.