Page 1 of 1
how to model gap element to get pounding force
Posted: 22 Nov 2015, 20:42
by tohamy
i need to model a gap element between two adjacent R.C frame buildings to get the pounding force and the response of the buildings. the manual is not clear about the gap link element, so i need a clear example or detailed explanation to steps of modeling the gap and getting the pounding force.
Re: how to model gap element to get pounding force
Posted: 23 Nov 2015, 13:05
by z.gronti
Dear tohamy,
If you carry out a search on this forum for the term "gap element" you may find a number of posts on this matter.
I think that the below topic might also help you
http://www.seismosoft.com/forum/viewtop ... hook#p3423
Re: how to model gap element to get pounding force
Posted: 05 Dec 2015, 21:05
by tohamy
sorry but the answers was not useful. i need just one example if any.