Page 1 of 1
Modeling masonry infill panels
Posted: 15 Jun 2010, 16:55
by moutra
I was wondering if i can use the infill panel model already existed in seismostruct to model an infill panel with the frame to be made of timber, if i adjust the parameters required.
Re: Modeling masonry infill panels
Posted: 24 Jun 2010, 12:34
by seismosoft
Dear Paraskevas Kontogiannis,
If you adjust the parameters correctly and coherently, you should be able to model any type of structural configuration.
The difficulty, of course, is in finding such correct parameters; availability of experimental results will obviously help.
Seismosoft Support