Page 1 of 1
permanent loading problem
Posted: 15 Sep 2014, 22:07
by arifrahman
when i try to run the model everytime it shows permanent loading error.the program do not run.If amyone give me a proper solution I will be very gratefull to him.
Re: permanent loading problem
Posted: 15 Sep 2014, 23:56
by huffte
Hi arifrahman. I notice this is your first post, so you are likely not aware of the excellent forum search feature.
If you will perform a forum search on 'unable to apply' (do not include the quote marks when you enter the phrase) you will get a lot of previous posts on this topic which should help you pinpoint your problem.
Best of luck arifrahman.
Re: permanent loading problem
Posted: 16 Sep 2014, 23:02
by arifrahman
Can you please check the project from the following link
https://www.dropbox.com/s/8t6hdw4kw2e74 ... t.spf?dl=0
and sove the problem and notify me where my fault was?
I will be very grateful to you [:)]
Re: permanent loading problem
Posted: 17 Sep 2014, 05:55
by huffte
Your deck is over 8 meters wide and 0.2 meters thick and it has 12 14 mm bars. It is no surprise that it will not run. Did you give consideration to modeling the deck as elastic? Modeling a footing as a 7m x 7m cross section is highly unusual. The pier cap is over 8 meters wide and 2 meters deep with very little reinforcing. Did you really expect to have these reinforced sections hold up? Perhaps you intended to model them as elastic elements?