Page 1 of 1

Error Message

Posted: 27 Aug 2009, 18:55
by kamran
I am running DAP analyses on RRC planer frames. But for most of the frames it gives the following error message and i cant run analyses. Some times the message is displayed even before the start of anaylses. The message is
"Access violation at address 695A3CEC in module 'nvoglv32.dll'.
Write of address 69FF360."
I am using Vista. I reinstalled the software for number of times but still i am facing the same problem.
Thanks

Re: Error Message

Posted: 13 Sep 2009, 08:05
by seismosoft
Yes, we did get the same error our selves, when we tried your model. We will investigate this matter further and hopefully solve it in the next release of the program, due for later this year.

Thank you for bringing this problem to our attention.

Seismosoft Support