Graph Stress vrs Height

[queren]

Hello everyone

I would be grateful if you could guide me on graphs that compare internal forces versus height in Seismostruct. Particularly I am modeling is a discretized column in more than one element and applying an axial and lateral point load at the free end.
The closest I have found is in the Action Effects Diagrams tab, however my interest is a graph plotting the variation of the internal forces of the elements in which I have discretized a cantilevered column versus the height of that column


Thank you in advance for your guidance

[seismosoft]

I am not sure I understand with what you mean with the comparison between internal forces and height. I note that you can monitor the stresses of the monitoring points inside the section using the Stress Points facility (Pre-processor>Output module).
Seismosoft Support