Is Programming/External Control possible in SeismoStruct?

[brisidi]

Hello everyone!

I was wondering if there is any possibility in SeismoStruct to do some programming. I could not answer this question myself, so I am hoping for an answer here. Programming can be useful for modeling, or for any sort of simulation (like for instance, Monte Carlo simulations for fragility analysis etc.). In some other software you can do this (for example, in Sap2000 you can externally control the program using Open Application Programming Interface OAPI in Matlab or VBA) and it would be very useful if SeismoStruct allowed that too.

Best regards!

[seismosoft]

You can use the SeismoBatch program (included in the SeismoStruct installation) to carry our multiple analyses and automatically extract the analuytical results.Refer to the manual or he help of the program for further information.
Regards,
Seismosoft Support