Hi,
I am conducting cyclic testing of beam column joint.The input time history curve has 8 cycles .While running the analysis ,the model runs upto 4 cycles and then shows "unable to run analysis , analysis is terminated" . How do I run the analysis for complete 8 cycles???.Please reply as soon as possible.
Thank You.
ANALYSIS GETS TERMINATED
Re: ANALYSIS GETS TERMINATED
Dear nayanhosmane,
You will find a number of posts on this matter if you carry out a search on this forum for the term "unable to apply".
Also, you may find a list with the convergence difficulties that may arrise and their solution in the User Manual, the Help System and in the video below:
https://www.facebook.com/22301629122752 ... 444459842/
https://www.youtube.com/watch?v=p6tAyoofDog
You will find a number of posts on this matter if you carry out a search on this forum for the term "unable to apply".
Also, you may find a list with the convergence difficulties that may arrise and their solution in the User Manual, the Help System and in the video below:
https://www.facebook.com/22301629122752 ... 444459842/
https://www.youtube.com/watch?v=p6tAyoofDog
Zoi Gronti
Seismosoft Srl.
Seismosoft Srl.