Page 1 of 1
Setting Default Rebar Diameter
Posted: 08 Feb 2019, 02:42
by Ralazem
Is there anyway to insert a rebar diameter size that is not on the drop down list?
Re: Setting Default Rebar Diameter
Posted: 08 Feb 2019, 10:22
by z.gronti
Dear Ralazem,
You may define the preferred diameter by inserting Additional Reinforcing Bars in the RC section and assigning the area of the diameter you want to.
Re: Setting Default Rebar Diameter
Posted: 12 Feb 2019, 03:41
by Ralazem
but then I run into the issue of the placement of the bar. It is not very exact using the x and y axis.
Re: Setting Default Rebar Diameter
Posted: 12 Feb 2019, 09:47
by z.gronti
Dear Ralazen,
I am afraid that there is no other way to introduce different reinforcement bar diameter from the predefined within SeismoStruct apart from the Additional Reinforcing Bars. I do not know what you want to model, but are you sure that the required precision in the location of the reinforcement bars is larger than the one you can get within the Additional Reinforcing Bars module?