Dear All,
I have modelled a 4 storey Steel frame in Seismostruct 2016 and I ran a Dynamic Time-History Analysis for specific seismic event (scale=1.0, completed successfully). Next, I ran an Incremental Dynamic Analysis for the same frame using the same seismic input applying the factors 0.1, 1.2, 0.1 for start, end and step scaling factors respectively, and the model completed the first 6 steps of analysis (up to scale 0.6) and then stopped, as it was “unable to apply the next step load”. Without changing the aforementioned model, I just applied the following scaling factors 0.1, 1.2, 0.05 (start, end and step respectively) and again my model completed the first 6 step of analysis (reaching 1.35 scale), but was unable to continue.
I would like to ask why this thing happens, and whether I need to change any parameters in order to make my model run all the steps (i.e. convergence criteria, iterative strategy etc.).
Thank you in advance,
Regards
Scale Factors
Re: Scale Factors
Dear ramin moskochi,
You may find a list with the convergence difficulties that may arise and their solution in SeismoStruct's User Manual and Help System, as well as in the video below:
https://www.facebook.com/pg/SeismoSoft- ... e_internal
https://www.youtube.com/watch?v=p6tAyoofDog
You will also find a number of posts on this matter if you carry out a search on this forum for the term "unable to apply".
You may find a list with the convergence difficulties that may arise and their solution in SeismoStruct's User Manual and Help System, as well as in the video below:
https://www.facebook.com/pg/SeismoSoft- ... e_internal
https://www.youtube.com/watch?v=p6tAyoofDog
You will also find a number of posts on this matter if you carry out a search on this forum for the term "unable to apply".
Zoi Gronti
Seismosoft Srl.
Seismosoft Srl.